Commit 908a7733 authored by Murali Karicheri's avatar Murali Karicheri Committed by David S. Miller
Browse files

dt-bindings: phy: dp83867: provide a workaround for incorrect RX_CTRL pin strap

The data manual for DP83867IR/CR, SNLS484E[1], revised march 2017,
advises that strapping RX_DV/RX_CTRL pin in mode 1 and 2 is not
supported (see note below Table 5 (4-Level Strap Pins)).

It further advises that if a board has this pin strapped in mode 1 and
mode 2, then to ensure proper operation of the PHY, a software workaround
must be implemented.

Since it is not possible to detect in software if RX_DV/RX_CTRL pin is
incorrectly strapped, add a device-tree property for the board to
advertise this and allow corrective action in software.

[1] http://www.ti.com/lit/ds/snls484e/snls484e.pdf

Signed-off-by: default avatarMurali Karicheri <m-karicheri2@ti.com>
[nsekhar@ti.com: rebase to mainline, split documentation into separate patch]
Signed-off-by: default avatarSekhar Nori <nsekhar@ti.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent a778427e
......@@ -18,6 +18,13 @@ Optional property:
- ti,max-output-impedance - MAC Interface Impedance control to set
the programmable output impedance to
maximum value (70 ohms).
- ti,dp83867-rxctrl-strap-quirk - This denotes the fact that the
board has RX_DV/RX_CTRL pin strapped in
mode 1 or 2. To ensure PHY operation,
there are specific actions that
software needs to take when this pin is
strapped in these modes. See data manual
for details.
Note: ti,min-output-impedance and ti,max-output-impedance are mutually
exclusive. When both properties are present ti,max-output-impedance
......
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment