Commit e6907663 authored by Lorenzo Bianconi's avatar Lorenzo Bianconi Committed by Jonathan Cameron
Browse files

dt-bindings: iio: imu: st_lsm6dsx: support open drain mode


Signed-off-by: default avatarLorenzo Bianconi <lorenzo.bianconi@st.com>
Acked-by: default avatarRob Herring <robh@kernel.org>
Signed-off-by: default avatarJonathan Cameron <jic23@kernel.org>
parent ff5fff4a
......@@ -11,6 +11,14 @@ Required properties:
Optional properties:
- st,drdy-int-pin: the pin on the package that will be used to signal
"data ready" (valid values: 1 or 2).
- drive-open-drain: the interrupt/data ready line will be configured
as open drain, which is useful if several sensors share the same
interrupt line. This is a boolean property.
(This binding is taken from pinctrl/pinctrl-bindings.txt)
If the requested interrupt is configured as IRQ_TYPE_LEVEL_HIGH or
IRQ_TYPE_EDGE_RISING a pull-down resistor is needed to drive the line
when it is not active, whereas a pull-up one is needed when interrupt
line is configured as IRQ_TYPE_LEVEL_LOW or IRQ_TYPE_EDGE_FALLING.
- interrupt-parent: should be the phandle for the interrupt controller
- interrupts: interrupt mapping for IRQ. It should be configured with
flags IRQ_TYPE_LEVEL_HIGH, IRQ_TYPE_EDGE_RISING, IRQ_TYPE_LEVEL_LOW or
......
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment