The target's status interface has to provide the new 'data_offset' value
to allow userspace to retrieve the kernels offset to the data on each
raid device of a raid set.  This is the base for out-of-place reshaping
required to not write over any data during reshaping (e.g. change
raid6_zr -> raid6_nc):

 - add rs_set_cur() to be able to start up existing array in case of no
   takeover; use in ctr on takeover check

 - enhance raid_status()

 - add supporting functions to get resync/reshape progress and raid
   device status chars

 - fixup rebuild table line output race, which does miss to emit
   'rebuild N' on fully synced/rebuild devices, because it is relying on
   the transient 'In_sync' raid device flag

 - add new status line output for 'data_offset', which'll later be used
   for out-of-place reshaping

 - fixup takeover not working for all levels

 - fixup raid0 message interface oops caused by missing checks
   for the md threads, which don't exist in case of raid0

 - remove ALL_FREEZE_FLAGS not needed for takeover

 - adjust comments

Signed-off-by: Heinz Mauelshagen <heinzm@redhat.com>
Signed-off-by: Mike Snitzer <snitzer@redhat.com>