Commit 1b99e5e8 authored by David S. Miller's avatar David S. Miller
Browse files

Merge branch 'stmmac-OXNAS'

Neil Armstrong says:

====================
net: stmmac: Add OXNAS DWMAC Glue

This patchset add support for the Sysnopsys DWMAC Gigabit Ethernet
controller Glue layer of the Oxford Semiconductor OX820 SoC.

Changes since v2 at http://lkml.kernel.org/r/20161031105345.16711-1-narmstrong@baylibre.com :
 - Disable/Unprepare clock if regmap read fails in oxnas_dwmac_init

Changes since v1 at https://patchwork.kernel.org/patch/9388231/ :
 - Split dt-bindings in a separate patch
 - Add IP version in the dt-bindings compatible
 - Check return of clk_prepare_enable()
 - use get_stmmac_bsp_priv() helper
 - hardwire setup values in oxnas_dwmac_init()

Changes since RFC at https://patchwork.kernel.org/patch/9387257

 :
 - Drop init/exit callbacks
 - Implement proper remove and PM callback
 - Call init from probe
 - Disable/Unprepare clock if stmmac probe fails
====================
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parents d3bc29a4 52b6c5c2
* Oxford Semiconductor OXNAS DWMAC Ethernet controller
The device inherits all the properties of the dwmac/stmmac devices
described in the file stmmac.txt in the current directory with the
following changes.
Required properties on all platforms:
- compatible: For the OX820 SoC, it should be :
- "oxsemi,ox820-dwmac" to select glue
- "snps,dwmac-3.512" to select IP version.
- clocks: Should contain phandles to the following clocks
- clock-names: Should contain the following:
- "stmmaceth" for the host clock - see stmmac.txt
- "gmac" for the peripheral gate clock
- oxsemi,sys-ctrl: a phandle to the system controller syscon node
Example :
etha: ethernet@40400000 {
compatible = "oxsemi,ox820-dwmac", "snps,dwmac-3.512";
reg = <0x40400000 0x2000>;
interrupts = <GIC_SPI 8 IRQ_TYPE_LEVEL_HIGH>,
<GIC_SPI 17 IRQ_TYPE_LEVEL_HIGH>;
interrupt-names = "macirq", "eth_wake_irq";
mac-address = [000000000000]; /* Filled in by U-Boot */
phy-mode = "rgmii";
clocks = <&stdclk CLK_820_ETHA>, <&gmacclk>;
clock-names = "gmac", "stmmaceth";
resets = <&reset RESET_MAC>;
/* Regmap for sys registers */
oxsemi,sys-ctrl = <&sys>;
status = "disabled";
};
......@@ -69,6 +69,17 @@ config DWMAC_MESON
the stmmac device driver. This driver is used for Meson6,
Meson8, Meson8b and GXBB SoCs.
config DWMAC_OXNAS
tristate "Oxford Semiconductor OXNAS dwmac support"
default ARCH_OXNAS
depends on OF && COMMON_CLK && (ARCH_OXNAS || COMPILE_TEST)
select MFD_SYSCON
help
Support for Ethernet controller on Oxford Semiconductor OXNAS SoCs.
This selects the Oxford Semiconductor OXNASSoC glue layer support for
the stmmac device driver. This driver is used for OX820.
config DWMAC_ROCKCHIP
tristate "Rockchip dwmac support"
default ARCH_ROCKCHIP
......
......@@ -10,6 +10,7 @@ obj-$(CONFIG_STMMAC_PLATFORM) += stmmac-platform.o
obj-$(CONFIG_DWMAC_IPQ806X) += dwmac-ipq806x.o
obj-$(CONFIG_DWMAC_LPC18XX) += dwmac-lpc18xx.o
obj-$(CONFIG_DWMAC_MESON) += dwmac-meson.o dwmac-meson8b.o
obj-$(CONFIG_DWMAC_OXNAS) += dwmac-oxnas.o
obj-$(CONFIG_DWMAC_ROCKCHIP) += dwmac-rk.o
obj-$(CONFIG_DWMAC_SOCFPGA) += dwmac-altr-socfpga.o
obj-$(CONFIG_DWMAC_STI) += dwmac-sti.o
......
/*
* Oxford Semiconductor OXNAS DWMAC glue layer
*
* Copyright (C) 2016 Neil Armstrong <narmstrong@baylibre.com>
* Copyright (C) 2014 Daniel Golle <daniel@makrotopia.org>
* Copyright (C) 2013 Ma Haijun <mahaijuns@gmail.com>
* Copyright (C) 2012 John Crispin <blogic@openwrt.org>
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License version 2 as
* published by the Free Software Foundation.
*
* You should have received a copy of the GNU General Public License
* along with this program. If not, see <http://www.gnu.org/licenses/>.
*/
#include <linux/device.h>
#include <linux/io.h>
#include <linux/module.h>
#include <linux/of.h>
#include <linux/platform_device.h>
#include <linux/regmap.h>
#include <linux/mfd/syscon.h>
#include <linux/stmmac.h>
#include "stmmac_platform.h"
/* System Control regmap offsets */
#define OXNAS_DWMAC_CTRL_REGOFFSET 0x78
#define OXNAS_DWMAC_DELAY_REGOFFSET 0x100
/* Control Register */
#define DWMAC_CKEN_RX_IN 14
#define DWMAC_CKEN_RXN_OUT 13
#define DWMAC_CKEN_RX_OUT 12
#define DWMAC_CKEN_TX_IN 10
#define DWMAC_CKEN_TXN_OUT 9
#define DWMAC_CKEN_TX_OUT 8
#define DWMAC_RX_SOURCE 7
#define DWMAC_TX_SOURCE 6
#define DWMAC_LOW_TX_SOURCE 4
#define DWMAC_AUTO_TX_SOURCE 3
#define DWMAC_RGMII 2
#define DWMAC_SIMPLE_MUX 1
#define DWMAC_CKEN_GTX 0
/* Delay register */
#define DWMAC_TX_VARDELAY_SHIFT 0
#define DWMAC_TXN_VARDELAY_SHIFT 8
#define DWMAC_RX_VARDELAY_SHIFT 16
#define DWMAC_RXN_VARDELAY_SHIFT 24
#define DWMAC_TX_VARDELAY(d) ((d) << DWMAC_TX_VARDELAY_SHIFT)
#define DWMAC_TXN_VARDELAY(d) ((d) << DWMAC_TXN_VARDELAY_SHIFT)
#define DWMAC_RX_VARDELAY(d) ((d) << DWMAC_RX_VARDELAY_SHIFT)
#define DWMAC_RXN_VARDELAY(d) ((d) << DWMAC_RXN_VARDELAY_SHIFT)
struct oxnas_dwmac {
struct device *dev;
struct clk *clk;
struct regmap *regmap;
};
static int oxnas_dwmac_init(struct oxnas_dwmac *dwmac)
{
unsigned int value;
int ret;
/* Reset HW here before changing the glue configuration */
ret = device_reset(dwmac->dev);
if (ret)
return ret;
ret = clk_prepare_enable(dwmac->clk);
if (ret)
return ret;
ret = regmap_read(dwmac->regmap, OXNAS_DWMAC_CTRL_REGOFFSET, &value);
if (ret < 0) {
clk_disable_unprepare(dwmac->clk);
return ret;
}
/* Enable GMII_GTXCLK to follow GMII_REFCLK, required for gigabit PHY */
value |= BIT(DWMAC_CKEN_GTX) |
/* Use simple mux for 25/125 Mhz clock switching */
BIT(DWMAC_SIMPLE_MUX) |
/* set auto switch tx clock source */
BIT(DWMAC_AUTO_TX_SOURCE) |
/* enable tx & rx vardelay */
BIT(DWMAC_CKEN_TX_OUT) |
BIT(DWMAC_CKEN_TXN_OUT) |
BIT(DWMAC_CKEN_TX_IN) |
BIT(DWMAC_CKEN_RX_OUT) |
BIT(DWMAC_CKEN_RXN_OUT) |
BIT(DWMAC_CKEN_RX_IN);
regmap_write(dwmac->regmap, OXNAS_DWMAC_CTRL_REGOFFSET, value);
/* set tx & rx vardelay */
value = DWMAC_TX_VARDELAY(4) |
DWMAC_TXN_VARDELAY(2) |
DWMAC_RX_VARDELAY(10) |
DWMAC_RXN_VARDELAY(8);
regmap_write(dwmac->regmap, OXNAS_DWMAC_DELAY_REGOFFSET, value);
return 0;
}
static int oxnas_dwmac_probe(struct platform_device *pdev)
{
struct plat_stmmacenet_data *plat_dat;
struct stmmac_resources stmmac_res;
struct device_node *sysctrl;
struct oxnas_dwmac *dwmac;
int ret;
sysctrl = of_parse_phandle(pdev->dev.of_node, "oxsemi,sys-ctrl", 0);
if (!sysctrl) {
dev_err(&pdev->dev, "failed to get sys-ctrl node\n");
return -EINVAL;
}
ret = stmmac_get_platform_resources(pdev, &stmmac_res);
if (ret)
return ret;
plat_dat = stmmac_probe_config_dt(pdev, &stmmac_res.mac);
if (IS_ERR(plat_dat))
return PTR_ERR(plat_dat);
dwmac = devm_kzalloc(&pdev->dev, sizeof(*dwmac), GFP_KERNEL);
if (!dwmac)
return -ENOMEM;
dwmac->dev = &pdev->dev;
plat_dat->bsp_priv = dwmac;
dwmac->regmap = syscon_node_to_regmap(sysctrl);
if (IS_ERR(dwmac->regmap)) {
dev_err(&pdev->dev, "failed to have sysctrl regmap\n");
return PTR_ERR(dwmac->regmap);
}
dwmac->clk = devm_clk_get(&pdev->dev, "gmac");
if (IS_ERR(dwmac->clk))
return PTR_ERR(dwmac->clk);
ret = oxnas_dwmac_init(dwmac);
if (ret)
return ret;
ret = stmmac_dvr_probe(&pdev->dev, plat_dat, &stmmac_res);
if (ret)
clk_disable_unprepare(dwmac->clk);
return ret;
}
static int oxnas_dwmac_remove(struct platform_device *pdev)
{
struct oxnas_dwmac *dwmac = get_stmmac_bsp_priv(&pdev->dev);
int ret = stmmac_dvr_remove(&pdev->dev);
clk_disable_unprepare(dwmac->clk);
return ret;
}
#ifdef CONFIG_PM_SLEEP
static int oxnas_dwmac_suspend(struct device *dev)
{
struct oxnas_dwmac *dwmac = get_stmmac_bsp_priv(dev);
int ret;
ret = stmmac_suspend(dev);
clk_disable_unprepare(dwmac->clk);
return ret;
}
static int oxnas_dwmac_resume(struct device *dev)
{
struct oxnas_dwmac *dwmac = get_stmmac_bsp_priv(dev);
int ret;
ret = oxnas_dwmac_init(dwmac);
if (ret)
return ret;
ret = stmmac_resume(dev);
return ret;
}
#endif /* CONFIG_PM_SLEEP */
static SIMPLE_DEV_PM_OPS(oxnas_dwmac_pm_ops,
oxnas_dwmac_suspend, oxnas_dwmac_resume);
static const struct of_device_id oxnas_dwmac_match[] = {
{ .compatible = "oxsemi,ox820-dwmac" },
{ }
};
MODULE_DEVICE_TABLE(of, oxnas_dwmac_match);
static struct platform_driver oxnas_dwmac_driver = {
.probe = oxnas_dwmac_probe,
.remove = oxnas_dwmac_remove,
.driver = {
.name = "oxnas-dwmac",
.pm = &oxnas_dwmac_pm_ops,
.of_match_table = oxnas_dwmac_match,
},
};
module_platform_driver(oxnas_dwmac_driver);
MODULE_AUTHOR("Neil Armstrong <narmstrong@baylibre.com>");
MODULE_DESCRIPTION("Oxford Semiconductor OXNAS DWMAC glue layer");
MODULE_LICENSE("GPL v2");
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment