Commit 83e37e0b authored by Rakesh Pillai's avatar Rakesh Pillai Committed by Johannes Berg
Browse files

mac80211: Restore vif beacon interval if start ap fails

The starting of AP interface can fail due to invalid
beacon interval, which does not match the minimum gcd
requirement set by the wifi driver. In such case, the
beacon interval of that interface gets updated with
that invalid beacon interval.

The next time that interface is brought up in AP mode,
an interface combination check is performed and the
beacon interval is taken from the previously set value.

In a case where an invalid beacon interval, i.e. a beacon
interval value which does not satisfy the minimum gcd criteria
set by the driver, is set, all the subsequent trials to
bring that interface in AP mode will fail, even if the
subsequent trials have a valid beacon interval.

To avoid this, in case of a failure in bringing up an
interface in AP mode due to interface combination error,
the interface beacon interval which is stored in bss
conf, needs to be restored with the last working value
of beacon interval.

Tested on ath10k using WCN3990.

Fixes: 0c317a02

 ("cfg80211: support virtual interfaces with different beacon intervals")
Signed-off-by: default avatarRakesh Pillai <>
Signed-off-by: default avatarJohannes Berg <>
parent 4ff3a9d1
......@@ -941,6 +941,7 @@ static int ieee80211_start_ap(struct wiphy *wiphy, struct net_device *dev,
int err;
int prev_beacon_int;
old = sdata_dereference(sdata->u.ap.beacon, sdata);
if (old)
......@@ -963,6 +964,7 @@ static int ieee80211_start_ap(struct wiphy *wiphy, struct net_device *dev,
sdata->needed_rx_chains = sdata->local->rx_chains;
prev_beacon_int = sdata->vif.bss_conf.beacon_int;
sdata->vif.bss_conf.beacon_int = params->beacon_interval;
if (params->he_cap)
......@@ -974,8 +976,10 @@ static int ieee80211_start_ap(struct wiphy *wiphy, struct net_device *dev,
if (!err)
ieee80211_vif_copy_chanctx_to_vlans(sdata, false);
if (err)
if (err) {
sdata->vif.bss_conf.beacon_int = prev_beacon_int;
return err;
* Apply control port protocol, this allows us to
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment