Commit e882a59e authored by Simon Glass's avatar Simon Glass Committed by Tom Rini
Browse files

net: Drop DM_PCI check from designware driver



We don't need this check anymore since when PCI is enabled, driver model
is always used.

Drop it.
Signed-off-by: Simon Glass's avatarSimon Glass <sjg@chromium.org>
parent d6d504d7
......@@ -756,16 +756,16 @@ int designware_eth_write_hwaddr(struct udevice *dev)
static int designware_eth_bind(struct udevice *dev)
{
#ifdef CONFIG_DM_PCI
static int num_cards;
char name[20];
/* Create a unique device name for PCI type devices */
if (device_is_on_pci_bus(dev)) {
sprintf(name, "eth_designware#%u", num_cards++);
device_set_name(dev, name);
if (IS_ENABLED(CONFIG_PCI)) {
static int num_cards;
char name[20];
/* Create a unique device name for PCI type devices */
if (device_is_on_pci_bus(dev)) {
sprintf(name, "eth_designware#%u", num_cards++);
device_set_name(dev, name);
}
}
#endif
return 0;
}
......@@ -831,12 +831,11 @@ int designware_eth_probe(struct udevice *dev)
else
reset_deassert_bulk(&reset_bulk);
#ifdef CONFIG_DM_PCI
/*
* If we are on PCI bus, either directly attached to a PCI root port,
* or via a PCI bridge, fill in plat before we probe the hardware.
*/
if (device_is_on_pci_bus(dev)) {
if (IS_ENABLED(CONFIG_PCI) && device_is_on_pci_bus(dev)) {
dm_pci_read_config32(dev, PCI_BASE_ADDRESS_0, &iobase);
iobase &= PCI_BASE_ADDRESS_MEM_MASK;
iobase = dm_pci_mem_to_phys(dev, iobase);
......@@ -844,7 +843,6 @@ int designware_eth_probe(struct udevice *dev)
pdata->iobase = iobase;
pdata->phy_interface = PHY_INTERFACE_MODE_RMII;
}
#endif
debug("%s, iobase=%x, priv=%p\n", __func__, iobase, priv);
ioaddr = iobase;
......
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment