Commit b4a2cdc1 authored by Marek Vasut's avatar Marek Vasut Committed by Stefano Babic
Browse files

arm: mxs: Increase VDDD voltage to match specification



According to IMX28CEC rev. 4, 10/2018, Table 15. Recommended Operating
Conditions, page 16, the VDDD should be set to 1.55V when the CPU is
operating at 454MHz. This is the case in U-Boot, hence increase the
VDDD voltage. This fixes instability when performing TFTP transfers.
Increase the brownout threshold to 1.4V. The documentation recommends
1.45V setting for the brownout, however, this triggers failure during
power block init, so keep the brownout slightly lower.
Signed-off-by: Marek Vasut's avatarMarek Vasut <marex@denx.de>
Cc: Stefano Babic <sbabic@denx.de>
Reviewed-by: default avatarFabio Estevam <festevam@gmail.com>
parent dde31a14
......@@ -1254,8 +1254,8 @@ void mxs_power_init(void)
debug("SPL: Setting VDDIO to 3V3 (brownout @ 3v15)\n");
mxs_power_set_vddx(&mxs_vddio_cfg, 3300, 3150);
debug("SPL: Setting VDDD to 1V5 (brownout @ 1v315)\n");
mxs_power_set_vddx(&mxs_vddd_cfg, 1500, 1315);
debug("SPL: Setting VDDD to 1V55 (brownout @ 1v400)\n");
mxs_power_set_vddx(&mxs_vddd_cfg, 1550, 1400);
#ifdef CONFIG_MX23
debug("SPL: Setting mx23 VDDMEM to 2V5 (brownout @ 1v7)\n");
mxs_power_set_vddx(&mxs_vddmem_cfg, 2500, 1700);
......
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment