Commit 9f709b6c authored by wdenk's avatar wdenk
Browse files

Fix INKA4x0: use CS1 as gpio_wkup_6 output

parent a6310928
......@@ -2,6 +2,8 @@
Changes for U-Boot 1.1.3:
======================================================================
* Fix INKA4x0: use CS1 as gpio_wkup_6 output
* Fix bug in the SDRAM initialization code for canmb, IceCube and
PM520 boards.
Fix PHY address for canmb board.
......
......@@ -197,8 +197,8 @@
/*
* GPIO configuration
*
* use pin gpio_wkup_6 as second SDRAM chip select (mem_cs1):
* Bit 0 (mask: 0x80000000): 1
* use CS1 as gpio_wkup_6 output
* Bit 0 (mask: 0x80000000): 0
* use ALT CAN position: Bits 2-3 (mask: 0x30000000):
* 00 -> No Alternatives, I2C1 is used for onboard EEPROM
* 01 -> CAN1 on I2C1, CAN2 on Tmr0/1 do not use on TQM5200 with onboard
......@@ -206,14 +206,8 @@
* use PSC1 as UART: Bits 28-31 (mask: 0x00000007): 0100
* use PSC6_1 and PSC6_3 as GPIO: Bits 9:11 (mask: 0x07000000):
* 011 -> PSC6 could not be used as UART or CODEC. IrDA still possible.
* GPIO on PSC6_3 is used in post_hotkeys_pressed() to enable extended POST
* tests.
*/
#if defined (CONFIG_MINIFAP)
#define CFG_GPS_PORT_CONFIG 0x93000004
#else
#define CFG_GPS_PORT_CONFIG 0x81001004
#endif
#define CFG_GPS_PORT_CONFIG 0x01001004
/*
* RTC configuration
......
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment