Commit d3c96b9b authored by Vincent Chen's avatar Vincent Chen Committed by Leo Yu-Chi Liang
Browse files

board: sifive: unmatched: refine GEMGXL initialized function in SPL



Create a new function spl_reset_device_by_gpio to reset the device
whose reset pin is connected to the GPIO. Then, using this function
to initialize GEMGXL.
Signed-off-by: default avatarVincent Chen <vincent.chen@sifive.com>
Reviewed-by: default avatarLeo Yu-Chi Liang <ycliang@andestech.com>
parent e52b83ab
......@@ -22,43 +22,63 @@
#define MODE_SELECT_SD 0xb
#define MODE_SELECT_MASK GENMASK(3, 0)
int spl_board_init_f(void)
static inline int spl_reset_device_by_gpio(const char *label, int pin, int low_width)
{
int ret;
ret = spl_soc_init();
ret = gpio_request(pin, label);
if (ret) {
debug("HiFive Unmatched FU740 SPL init failed: %d\n", ret);
debug("%s gpio request failed: %d\n", label, ret);
return ret;
}
ret = gpio_direction_output(pin, 1);
if (ret) {
debug("%s gpio direction set failed: %d\n", label, ret);
return ret;
}
udelay(1);
gpio_set_value(pin, 0);
udelay(low_width);
gpio_set_value(pin, 1);
return ret;
}
static inline int spl_gemgxl_init(void)
{
int ret;
/*
* GEMGXL init VSC8541 PHY reset sequence;
* leave pull-down active for 2ms
*/
udelay(2000);
ret = gpio_request(GEM_PHY_RESET, "gem_phy_reset");
ret = spl_reset_device_by_gpio("gem_phy_reset", GEM_PHY_RESET, 1);
mdelay(15);
return ret;
}
int spl_board_init_f(void)
{
int ret;
ret = spl_soc_init();
if (ret) {
debug("gem_phy_reset gpio request failed: %d\n", ret);
return ret;
debug("HiFive Unmatched FU740 SPL init failed: %d\n", ret);
goto end;
}
/* Set GPIO 12 (PHY NRESET) */
ret = gpio_direction_output(GEM_PHY_RESET, 1);
ret = spl_gemgxl_init();
if (ret) {
debug("gem_phy_reset gpio direction set failed: %d\n", ret);
return ret;
debug("Gigabit ethernet PHY (VSC8541) init failed: %d\n", ret);
goto end;
}
udelay(1);
/* Reset PHY again to enter unmanaged mode */
gpio_set_value(GEM_PHY_RESET, 0);
udelay(1);
gpio_set_value(GEM_PHY_RESET, 1);
mdelay(15);
return 0;
end:
return ret;
}
u32 spl_boot_device(void)
......
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment