-
u-boot-stm32-20200401
- Fix device tree of Avenger96 board from Arrow Electronics and add compatibility with stm32mp15_dhcom_basic_defconfig
-
u-boot-stm32-20200415
- Replace STM32MP1_TRUSTED by TFABOOT flag - Enable bootd, iminfo, imxtract on ST defconfig - Rename LEDs to match silkscreen on AV96 - Add KS8851-16MLL ethernet on FMC2 - Define FMC2 base address - net: dwc_eth_qos: implement reset-gpios for stm32 - net: dwc_eth_qos: implement phy reg and max-speed for stm32
-
u-boot-stm32-20200424
- Solve stm32mp15 pinctrl dts issue (patch conflict in branches master and next) - Split device tree for DHCOR Som and AV 96 board - Update PLL4 setting in AV96 board - Enable bootd, iminfo, imxtract on DHCOM
-
u-boot-stm32-20200514
- stm32mp1: migrate MTD and DFU configuration in Kconfig - stm32mp1: add command stm32prog - stm32mp1: several board and arch updates - stm32mp1: activate data cache in SPL and before relocation - Many improvment for AV96 board and DHCOR SoM (add new defconfig, DDR3 coding on DHCOR SoM, split between board and SOM Synchronize DDR setttings on DH SoMs, setting for I2C EEPROM) - clk: stm32mp1: fix CK_MPU calculation - DT alignment of stm32mp1 device tree with Linux 5.7-rc2
-
u-boot-stm32-20200528
- stm32mp15: fix DT on DHCOR SOM and avenger96 board - stm32mp15: re-enable KS8851 on DHCOM
-
-
u-boot-stm32-20200616
- fix boot with OP-TEE for stm32mp15 boards
-
u-boot-stm32-20200619
- fix SD card cart detect on DHCOM and ST boards
-
-
-
u-boot-stm32-20200707
- arch and board update for stm32mp15: - use OPP information in device tree for 800MHz/650MHz support - ram: inprovments of test command - solve boot on closed chip when access to DBGMCU_IDC is protected - stm32prog command: Add "device anme" during USB enumeration - update configs: activate WATCHDOG and 'env erase' command, increase teed partition, support SD card after NOR boot by default and use env info in env_check - some sboard cleanups: gpio hog in dh board, specific driver for type-c stusb1600 controller code in a driver move part of code in spl.c and in common directory - fix STM32 compatible for dwc_eth_qos driver - support of new pinctrl ops get_dir_flags/set_dir_flags in stm32 and stmfx drivers - vrefbuf: fix a possible overshoot when re-enabling
-
-
u-boot-stm32-20200729
- fix SPL boot issue due to early dbgmcu_init() call - fix SPL boot issue due to dcache memory region configuration - add support of CONFIG_ENV_IS_IN_MMC - add specific SD/eMMC partition for U-Boot enviromnent - enable env in SPL - use "env info -q" to remove log during boot - remove env location override for dh_stm32mp1 - update management of misc_read - check result of find_mmc_device in stm32prog - use regulator_set_enable_if_allowed for disabling vdd supply in usbphyc - enable CMD_ADTIMG flag to handle Android images - device tree alignment with Linux Kernel v5.8-rc1 - remove hnp-srp-disable for usbotg on dk1 - add reset support to uart nodes on stm32mp15x - use correct weak function name spl_board_prepare_for_linux - use cd-gpios for ST and DHSOM boards - add seeed studio odyssey-stm32mp157c board support - move ethernet PHY into SoM DT - add DHSOM based DRC02 board support
-
-
u-boot-stm32-20200813
- Use IS_ENABLED to prevent ifdef in board_key_check for STM32MP - Add STM32 FMC2 EBI controller driver - Fix dwc3-sti-glue which allows STiH410-B2260 to boot again - Add fitImage its entry for 587-200 DHCOR SoM - Add both PDK2 and DRC02 DT into DHCOM fitImage its - Fix DHCOM KS8851 ethernet MAC address - Remove stm32mp1 board.c file - Use const for struct node_info in board stm32mp1.c file
-
-
-
u-boot-stm32-20200909
- fixes on AV96 board: pull up on UART4 RX and adjust PLL4
-
u-boot-stm32-20201002
- Fixup SPI-NOR boot on AV96 board
-
u-boot-stm32-20201003
- stm32mp: DT alignment with Linux 5.9-rc4 - stm32mp: convert drivers to APIs which support live DT - stm32mp: gpio: minor fixes