Patrice Chotard authored Mar 30, 2022 and Tom Rini committed May 23, 2022

Now, spi_flash_probe_bus_cs() relies on DT for spi speed and mode
and logically calls spi_get_bus_and_cs(). In case spi mode and speed are
not read from DT, make usage of spi_flash_probe() instead.

To sum-up:
 - Previous call tree was:
    spi_flash_probe() -> spi_flash_probe_bus_cs() -> spi_get_bus_and_cs()

 - Current call tree is:
    spi_flash_probe() -> _spi_get_bus_and_cs()
    spi_flash_probe_bus_cs() -> spi_get_bus_and_cs()

This patch impacts the following :
  - cmd/sf.c: if spi mode and/or speed is passed in argument of
    do_spi_flash_probe(), call spi_flash_probe() otherwise call
    spi_flash_probe_bus_cs().

  - drivers/net/fm/fm.c: as by default spi speed and mode was set to
    0 and a comment indicates that speed and mode are read from DT,
    use spi_flash_probe_bus_cs().

  - drivers/net/pfe_eth/pfe_firmware.c: spi speed and mode are not read
    from DT by all platforms using this driver, so keep legacy and replace
    s...