i2c: mxc: add a condition in case the parameter is NULL

This could avoid executing the code that only applies to i.MX platforms.

The bus_i2c_init() is called before relocation and will assgin value
to a static variable. If U-Boot is then still running in a flash
device, it's theoretically not allowed to write data to flash without
an erasing operation. For i.MX platforms, the U-Boot is always running
in DDR.

Actually it causes asynchronous error when the ARM64 system error
report is enabled and the flash write protect is set.

Signed-off-by: Gong Qianyu <Qianyu.Gong@freescale.com>
Reviewed-by: Heiko Schocher <hs@denx.de>

drivers/i2c/mxc_i2c.c

@@ -581,8 +581,16 @@ void bus_i2c_init(int index, int speed, int unused,
 		return;
 	}
 
-	mxc_i2c_buses[index].idle_bus_fn = idle_bus_fn;
-	mxc_i2c_buses[index].idle_bus_data = idle_bus_data;
+	/*
+	 * Warning: Be careful to allow the assignment to a static
+	 * variable here. This function could be called while U-Boot is
+	 * still running in flash memory. So such assignment is equal
+	 * to write data to flash without erasing.
+	 */
+	if (idle_bus_fn)
+		mxc_i2c_buses[index].idle_bus_fn = idle_bus_fn;
+	if (idle_bus_data)
+		mxc_i2c_buses[index].idle_bus_data = idle_bus_data;
 
 	ret = enable_i2c_clk(1, index);
 	if (ret < 0) {