Tags give the ability to mark specific points in history as being important
- Sort by
- Name
- Oldest updated
- Last updated
-
u-boot-stm32-20210409 Add rt-thread art-pi board support based on STM32H750 SoC Add Engicam i.Core STM32MP1 SoM Add FIP header support for STM32programmer Update uart number when no serial device found for STM32MP1 Remove board_check_usb_power function when ADC flag is not set Update SPL size limitation for STM32MP1 Set soc_type, soc_pkg, soc_rev env variables for STM32MP1
-
u-boot-stm32-20210312 - Add WATCHDOG_RESET() in MTD framework and STM32 QSPI driver - stm32mp1_trusted_defconfig rely on SCMI support - Remove the nand MTD configuration for NOR boot in stm32mp1 board - STM32programmer update - Bsec: manage clock when present in device tree - stm32mp15: move bootdelay configuration in defconfig - Update for stm32 dsi and dw_mipi_dsi - STM32 MCU's cleanup - Fix compilation issue depending on SYS_DCACHE_OFF and SYS_ICACHE_OFF flags - Update stm32mp1 doc
-
u-boot-stm32-20210226 - Add USB host boot support in stm32mp1 config - Enable uefi related commands for STMicroelectronics STM32MP15 boards - Remove duplicate uart nodes in stm32mp15 device tree
-
u-boot-stm32-20210209 - Enable the fastboot oem commands in stm32mp15 defconfig - Fixes pinctrol for stmfx and stm32 - Add support of I2C6_K in stm32mp15 clock driver - Alignment with Linux kernel device tree v5.11-rc2 for ST boards
-
u-boot-stm32-20210113 - Enable logging features for stm32mp15 boards - Update MAINTAINERS emails for STI and STM32 - Activate OF_LIVE for ST stm32mp15 boards - Switch to MCO2 for PHY 50 MHz clock for DHCOM boards - Correction in stm32prog command on uart: always flush DFU on start command - Update USB-C power detection algorithm on DK boards
-
v2021.01 Prepare v2021.01
-
u-boot-stm32-20210106 - Fix GPIO hog flags on DHCOM boards
-
u-boot-stm32-20201209 - Manage CONFIG_ENV_EXT4_DEVICE_AND_PART in stm32mp1 board - Update ARM STI and ARM STM STM32MP Arch maintainers emails - Enable internal pull-ups for SDMMC1 on DHCOM SoM
-
u-boot-stm32-20201125 - STM32 MCU's DT update - Add DHCOM based STM32MP15x PicoITX board - Correct ALIGN macro usage for on syram for SPL dcache support - Fixes on DHCOM: uSD card-detect GPIO and Drop QSPI CS2 - Fix compilation issue for spl_mmc_boot_partition - Fix MTD partitions for serial boot - Add support of MCU HOLD BOOT with reset for stm32 remoteproc (prepare alligneent with kernel DT) - Correct bias information and support in STM32 soc and STMFX - Support optional vbus in usbphyc - Update FIT examples to avoid kernel zImage relocation before decompression
-
v2021.01-rc1 Prepare v2021.01-rc1
-
u-boot-stm32-20201021 - Activate CMD_EXPORTENV/CMD_IMPORTENV/CMD_ELF for STM32MP15 defconfig - Fix stm32prog command: parsing of FlashLayout without partition - Update MAINTAINERS for ARM STM STM32MP - Manage eth1addr on dh board with KS8851 - Limit size of cacheable DDR in pre-reloc stage in stm32mp1 - Use mmc_of_parse() to read host capabilities in mmc:sdmmc2 driver
-
v2020.10 Prepare v2020.10
-
u-boot-stm32-20201003 - stm32mp: DT alignment with Linux 5.9-rc4 - stm32mp: convert drivers to APIs which support live DT - stm32mp: gpio: minor fixes
-
u-boot-stm32-20201002 - Fixup SPI-NOR boot on AV96 board
-
u-boot-stm32-20200909 - fixes on AV96 board: pull up on UART4 RX and adjust PLL4
-
v2020.10-rc4 Prepare v2020.10-rc4
-
v2020.10-rc3 Prepare v2020.10-rc3
-
u-boot-stm32-20200813 - Use IS_ENABLED to prevent ifdef in board_key_check for STM32MP - Add STM32 FMC2 EBI controller driver - Fix dwc3-sti-glue which allows STiH410-B2260 to boot again - Add fitImage its entry for 587-200 DHCOR SoM - Add both PDK2 and DRC02 DT into DHCOM fitImage its - Fix DHCOM KS8851 ethernet MAC address - Remove stm32mp1 board.c file - Use const for struct node_info in board stm32mp1.c file
-
v2020.10-rc2 Prepare v2020.10-rc2
-
u-boot-stm32-20200729 - fix SPL boot issue due to early dbgmcu_init() call - fix SPL boot issue due to dcache memory region configuration - add support of CONFIG_ENV_IS_IN_MMC - add specific SD/eMMC partition for U-Boot enviromnent - enable env in SPL - use "env info -q" to remove log during boot - remove env location override for dh_stm32mp1 - update management of misc_read - check result of find_mmc_device in stm32prog - use regulator_set_enable_if_allowed for disabling vdd supply in usbphyc - enable CMD_ADTIMG flag to handle Android images - device tree alignment with Linux Kernel v5.8-rc1 - remove hnp-srp-disable for usbotg on dk1 - add reset support to uart nodes on stm32mp15x - use correct weak function name spl_board_prepare_for_linux - use cd-gpios for ST and DHSOM boards - add seeed studio odyssey-stm32mp157c board support - move ethernet PHY into SoM DT - add DHSOM based DRC02 board support